Pontiac Fiero 1988 Service Manual page 183

3 B 4 - 1 4 STEERING WHEELS AND COLUMNS
7. R E M O V E AND I N S T A L L SHIFT T U B E , IGNITION AND DIMMER SWITCH A S S E M B L I E S
REMOVE
1. Remove parts as shown.
SCREW
SHIFT LEVER
GATE
PIN
SUPPORT
INSTALL
1. Install parts as shown.
Position rod in slider hole and install ignition switch.
G E ^ R SHIFT
LEVER BOWL
GEARSHIFT
BOWL
SHROUD
Install lower stud and tighten to 4.0 N-m.
Install dimmer switch and depress switch slightly to
insert 3 32" drill. Force switch up to remove lash,
then tighten screw, and nut to 4.0 N-m.
Place shifter in neutral and install shift lever.
IGNITION SWITCH
ACTUATOR ASSEMBLY
L-DIMMER SWITCH
ROD
'— SHIFT TUBE ASSEMBLY
(COLUMN SHIFT ONLY)
DIMMER SWITCH
ASSEMBLY
•RETAINER
•RETAINER CLIP
•LOWER BEARING
AND ADAPTER
STEERING COLUMN
HOLDING FIXTURE
-MOVE SWITCH SLIDER TO
EXTREME RIGHT POSITION
© K E Y R E L E A S E
L e a v e slider at e x t r e m e right
© PARK LOCK
M o v e s l i a e r o n e d e t e n t to
t h e left (off l o c k )
• A L L O T H E R C O L U M N S
M o v e s l i d e r t w o d e t e n t s to
the left (off u n l o c k )
INSTALL IGNITION SWITCH
ASSEMBLY
D I M M E R :
-3 32" Drill
S
IS
D
C H
ADJUST DIMMER SWITCH ASSEMBLY
KEY RELEASE
LEVER
J-23072
| KEY RELEASE
1 SPRING
REMOVE SHIFT
TUBE ASSEMBLY FROM BOWL
KEY RELEASE LEVER 3 8 3 0 5 1 0 2 0
Fig. 1 7 Adjustable Steering Column Service (3 of 3)