Pontiac Fiero 1988 Service Manual page 231

5-10
BRAKES
1 -
HOSE - REAR RH
6 - CLIP
2 - PIPE -
REAR LH 7 - FITTING
3 - HOSE
- R E A R L H 8 - BRACKET
4 -
PIPE - REAR RH 9 - COMBINATION V A L V E
S - PIPE - REAR BRAKES
1 0 - JUNCTION BLOCK
J 1 0 0 1 0 - 5 - P
Figure 10 Center and Rear Brake Pipes
* 4 - Install or Connect (Figure 9)
NOTICE: See "Notice" on page 5-1 for steps 1, 3
and 4.
1. Bolt, hose, and two copper gaskets to caliper.
• Use new copper gaskets.
• Lubricate bolt threads with brake fluid.
• Fitting flange must engage caliper orientation
ledge.
Tighten
• Bolt to 45 N-m (33 lbs. ft.).
2. Hose into bracket.
• There should be no kinks in hose.
3. Bolt attaching hose clip to upper control arm.
Tighten
Bolt to 6 N-m (54 lbs. in.).
4. Spring clip at hose mounting bracket.
5. Brake pipe to hose.
• Use backup wrench on hose fitting.
• Make sure that hose does not make contact
with any part of suspension. Check in extreme
right and extreme left turn conditions.
Tighten
• Fittings to 15 N-m (11 lbs. ft.).
6. Bleed brake system. See "Bleeding Brake Hydraulic
System" in this section.
7. Wheel and tire. See Section 3E.