Pontiac Fiero 1988 Service Manual page 313

6A1-12 2.5L ENGINE
8.
10.
11.
12.
Recheck bearing clearances using plastic gage
method.
K e y
from old
crankshaft keyway in the
crankshaft.
Crankshaft timing gear and
ALIGN TIMING
MARKS ON TIMING GEARS BY
ROTATING CRANKSHAFT IF
NECESSARY.
Timing gear cover using new seal.
Force balancer and oil pan, using new rear seal
in rear main bearing cap and new front seal in
timing gear cover.
13.
14
15
16
17.
18
Important
Force balancer must be aligned after
crankshaft is in place (see Force Balancer
procedure).
Coat front cover oil seal contact area of
pulley hub with oil and push into position.
Crankshaft pulley and hub.
Spark plugs.
Remove engine from stand.
Engine in car.
Add engine oil.
ON-CAR S E R V I C E
1 - E N G I N E M O U N T
2 - NUT- 56 N-m (41 L B . F T . )
3 - NUT- 48 N 9 m (35 L B . F T . )
4 - S H I E L D
5 - D R A I N H O L E - R E A R W A R D
A N D F R E E O F R U B B E R .
G20051 6A4
Fig. 801 Engine Mount to Frame
ENGINE AND T R A N S A X L E MOUNTS
Figs. 801802,803,804 and 806
Tool required:
J28467
Engine Support Fixture (and
attachments).
CAUTION:
S u p p o r t f i x t u r e J 2 8 4 6 7
m u s t b e l o c a t e d in c e n t e r o f c o w l a n d
i t s f a s t e n e r s p r o p e r l y t i g h t e n e d
b e f o r e s u p p o r t i n g e n g i n e a n d
t r a n s a x l e . B o d i l y i n j u r y c o u l d r e s u l t
w i t h i m p r o p e r u s e o f t h i s s u p p o r t
f i x t u r e .
Refer
to
Section
2 A f o r
i n s t a l l a t i o n o f t h i s e n g i n e s u p p o r t
f i x t u r e J 2 8 4 6 7 .
Engine Mount
J 4 - + | Remove or Disconnect
1. Engine compartment lid and side panels.
J 9
Important
• Scribe hinges for later reassembly.
2. Trim - at sail panel below battery side panel.
3.
Support engine with
J28467,
or other suitable
4.
5.
6.
7.
Bolt - engine torque strut.
Raise vehicle.
Nuts - engine mount to chassis.
Nuts - upper, mount to engine support bracket.
Engine mount.
Install or Connect
Support engine with
J28467,
position mount.
Nuts - mount to engine bracket (Fig. 801).
Nuts - mount to chassis (Fig. 801).
Lower vehicle.
Bolt - engine torque strut.
Remove support fixture.
Trim - at sail panel below battery side panel.
Engine compartment lid and side panels.
Automatic Transaxle Mount
Remove or Disconnect
1. Engine compartment lid and side panels.
Important
• Scribe hinges for later reassembly.
2. Trim - at sail panel below battery side panel.