Pontiac Fiero 1988 Service Manual page 219

4D-6 DRIVE AXLE
1.
REMOVE
AND I N S T A L L D E F L E C T O R RING
R E M O V E I N S T A L L
1. For damaged deflector ring, 1. Install part as shown,
remove parts as shown.
DEFLECTOR RING
AXLE ASSEMBLY WITH STEEL DEFLECTOR RING
AXLE ASSEMBLY WITH RUBBER DEFLECTOR RING
DEFLECTOR RING •
To install,
stretch ring and
seat properly
in groove
REMOVE AND INSTALL DEFLECTOR RING (RUBBER)
Use brass
drift to
tap off
deflector
ring
DEFLECTOR RING
REMOVE DEFLECTOR RING (STEEL)
SHEET STEEL (3mm MIN
THICKNESS) WITH 24mm
DRILLED HOLE-
DEFLECTOR
RING
2V
2
" PIPE
COUPLING
-M20 x 1.5
NUT
INSTALL DEFLECTOR RING (STEEL)
2. R E M O V E AND INSTALL O U T E R JOINT S E A L
REMOVE INSTALL
1. Cut seal retaining clamps.
2. Remove parts as shown.
-Seal groove
-AXLE SHAFT
SEAL
RETAINING
CLAMP
1. Flush grease from joint
and repack joint with
approx. half of grease
provided.
2. Put remainder of grease
in seal.
3. Install parts as shown. Use
tool J 35910 to secure seal
retaining clamp. Torque to
specifications.
SEAL
RETAINING
CLAMP
DEFLECTOR
RING-
RACE
RETAINING RING-
SEAL
RETAINING
CLAMP
REMOVE CLAMP AND RETAINER
Snap ring pliers
J-8059
Spread retaining ring
ears apart and
pull shaft out
RACE RETAINING RING
REMOVE JOINT ASSEMBLY
Push assembly
onto shaft until
retaining ring
is seated in groove
INSTALL JOINT ASSEMBLY
• Torque clamp
1
to 136 N-m
1 (100 ft lbs)-
Drive Axle
Seal Clamp
Tool
J 3 5 9 1 0
Torque clamp
to 176 NTTI
(130 ft. lbs.
-Torque
wrench
INSTALL SEAL RETAINING
CLAMP
J10252-4D-P
Figure 7 Unit Repair