Pontiac Fiero 1988 Service Manual page 199

3D-4
REAR SUSPENSION
1.
2.
1.
2.
•
1.
lnstaltOT€oiinecf
New hub nut on axle shaft.
p £ p Tighten
Apply PARTIAL torque to new hub nut
(approx. 100 Nnn ) (74 lb. ft.).
Install or Connect
Rotor.
Caliper assembly.
Tighten
Torque caliper mounting bolts to 48 N.m
(35 lb. ft.).
Install or Connect
Wheel and tire.
Lower vehicle.
|ijX| Tighten
Apply FINAL torque at hub nut to 270
N.m (200 lb. ft.).
install or Connect
Hub cap.
WHEEL CALIPER REMOVAL AND
INSTALLATION
Remove or Disconnect
Hoist vehicle
Tire and wheel.
Allen head mounting bolts.
Caliper from rotor.
Suspend caliper from frame with wire hook.
Rotor.
Install or Connect
1. See notice on page 1 of this section.
2. Rotor.
3. Caliper.
4. Allen head mounting bolts.
5. Tire and wheel.
6. Lower vehicle.
REAR KNUCKLE
r * | Remove or Disconnect
1. Raise vehicle.
2. Support front of vehicle with suitable jack
stands.
3. Install drive axle boot protector.
4. Wheel and tire.
5. Hub nut (discard).
6. Caliper and rotor.
7. Trailing arm at knuckle.
8. Fixed adjusting link/lateral control arm through
bolt.
9. Strut mounting bolts.
10. Hub/knuckle assembly from drive axle,
r—1
I*
4
! Install or Connect
1. Hub/knuckle assembly to drive axle.
2. Loosely install strut mounting bolts with bolt
head to rear.
3. Fixed adjusting link/lateral control arm through
bolt.
4. Trailing arm at knuckle with bolt head inboard.
5. Strut mounting bolts at knuckle.
6. Rotor and caliper
7. PARTIALLY torque New hub nut and washer
to 100 Nnn (74 lbs. ft.).
8. Remove drive axle seal boot protector.
9. Tire and wheel.
10. Remove jack stands.
11. Lower vehicle
12. Apply FINAL torque to hub nut and washer to
270 Nnn (200 lbs. ft.).
13. Set camber and toe as necessary.