Pontiac Fiero 1988 Service Manual page 182

S T E E R I N G W H E E L S AND COLUMNS 3 B 4 - 1 3
5. REMOVE AND INSTALL HOUSING
R E M O V E
1. Reinstall tilt lever and place c o l u m n in full
" U P " position.
2. Remove tilt spring and pivot pins.
3. Remove housing by pulling upward on tilt
lever and pull housing upward until it stops.
Move housing to the right to disengage
rack from actuator.
4. Remove tilt lever.
5. Remove parts as shown.
H O U S I N G -
I N S T A L L
1. Install parts as s h o w n .
2. While holding up on tilt lever to disengage
lock shoes install over steering shaft.
Move rack d o w n w a r d and hold. T i p
housing to the left until rack engages pin
on actuator rod. Push housing d o w n until
pivot pin holes are in alignment.
UPPER BEARING INNER RACE
SEAT
• L O C K B O L T
RELEASE
LEVER SPRING
SCREW
SWITCH A C T U A T O R
RACK
• I G N I T I O N S W I T C H
A C T U A T O R R O D
r Punch
Screwdriver
REMOVE DRIVE SHAFT
A N D SECTOR
R E M C V F T I L T S P R I N G R E T A I N E R .
SWITCH
p» A C T U A T O R
H R A C K ^
P I V O T P I N
J 2 1 8 5 4 - 0 1
R E M O V E P I V O T P I N S
IGNITION
SWITCH
A C T U A T O R
ROD
ENGAGE SWITCH
A C T U A T O R RACK
6. REMOVE AND INSTALL LOWER S T E E R I N G SHAFT A S S E M B L Y
R E M O V E I N S T A L L
1 R e m o v e parts as s h o w n 1 Install p a r t s as s h o w n .
BOWL &
SHROUD ASSEMBLY-
LOWER STEERING SHAFT ASSEMBLY
CENTERING SPHERE
n
RACE A N D UPPER SHAFT
\ ASSEMBLY
»30S1844
^ J O I N T PRELOAD SPRING
Fig. 16 Adjustable Steering Column Service (2 of 3)