Pontiac Fiero 1988 Service Manual page 314

2.5L ENGINE 6A1-13
1 - TRANSAXLE MOUNT BRACKET
2 - TRANSAXLE MOUNT
3 - NUT - 45 N-m (33 LB.FT.)
4 - BOLT - 54 N-m (40 LB.FT.)
5 - BOLT - 75 N-m (55 LB.FT.)
6 - NUT - 25 N-m (18 LB.FT.)
G20045-6A4
Fig. 802 Automatic Transaxle Mount
+ 4 .
3. Support engine and transaxle with J28467 (See
Section 2A).
4. Bolt - engine torque strut.
5. Upper mount nuts.
6. Raise vehicle.
7. Nuts - lower mount.
8. Mount.
Install or Connect
1. Position mount.
2. Nuts - lower mount - 45 N-m (33 lb. ft.)
3. Lower vehicle.
4. Nuts - upper mount - 45 N-m (33 lb. ft.).
5. Bolt - engine torque strut.
6. Remove support fixture.
7. Trim - at sail panel below battery side panel.
8. Engine compartment lid and side panels.
M a n u a l T r a n s m i s s i o n M o u n t s
Remove or Disconnect
1. Engine compartment lid and side panels.
Important
2.
3.
4.
5.
6.
• Scribe hinges for later reassembly.
Trim - at sail panel below battery side panel.
Support engine and transaxle with J28467.
Bolt - engine torque strut.
Raise vehicle.
Nuts - front mount to frame.
7. Nuts - rear mount to frame.
8. Nut - front mount to bracket.
9. Nut - rear mount to bracket.
10. Mounts, front and rear.
|»4-j Install or Connect
1. Position front and rear mounts.
2. Nut - rear mount to bracket - 48 N-m (35 lb. ft.).
3. Nut - front mount to bracket -
4. Nuts - rear mount to frame -
5. Nuts - front mount to frame •
6. Lower vehicle.
7. Bolt - engine torque strut.
8. Remove support fixture.
9. Trim - at sail panel below battery side panel.
10. Engine compartment lid and side panels.
Engine Torque S t r u t
4--M Remove or Disconnect
•48 N-m (35 lb. ft).
24 N-m (18 lb. ft).
-48 N-m
(35
lb.
ft.).
1. Rear strut bolt.
2. Front strut bolt.
3. Strut.
[HM^| Install or Connect
1. Loosely insert front strut bolt.
• Displace engine rearward with a horizontal
load of 200-250 Newtons, applied through
centerline of slots. Tighten while load is
applied.