Figure 28-9 Menu 11.6: Traffic Redirect Setup; Table 28-6 Menu 11.6: Traffic Redirect Setup - ZyXEL Communications ZyWall 10W User Manual

The following table describes the fields in this screen.
FIELD
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
Configuration:
Backup Enter the IP address of your backup gateway in dotted decimal notation.
Gateway IP
The ZyWALL automatically forwards traffic to this IP address if the
Address
ZyWALL's Internet connection terminates.
Metric Enter a number from 1 to 15 to set this route's priority among the
ZyWALL's routes (see the Metric section in the WAN and Dial Backup
Setup chapter) The smaller the number, the higher priority the route has.
Check WAN Enter the IP address of a reliable nearby computer (for example, your
IP Address ISP's DNS server address) to test your ZyWALL's WAN accessibility.
The ZyWALL uses the default gateway IP address if you do not enter an
IP address here.
If you are using PPTP or PPPoE Encapsulation, enter "0.0.0.0" to
configure the ZyWALL to check the PVC (Permanent Virtual Circuit) or
PPTP tunnel.
Remote Node Setup
Menu 11.6 - Traffic Redirect Setup
Active= Yes
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 2
Period (sec)= 5
Timeout (sec)= 3
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.

Figure 28-9 Menu 11.6: Traffic Redirect Setup

Table 28-6 Menu 11.6: Traffic Redirect Setup

ZyWALL Series Internet Security Gateway
DESCRIPTION EXAMPLE
Yes
0.0.0.0
15
(default)
0.0.0.0
28-13