ZyXEL Communications ZyWall 10W User Manual page 626

ZyWALL Series Internet Security Gateway
FUNCTION
Config edit firewall set <set
#> rule <rule #> log <none |
match | not-match | both>
Config edit firewall set <set
#> rule <rule #> alert <yes |
no>
config edit firewall set <set
#> rule <rule #> srcaddr-single
<ip address>
config edit firewall set <set
#> rule <rule #> srcaddr-subnet
<ip address> <subnet mask>
config edit firewall set <set
#> rule <rule #> srcaddr-range
<start ip address> <end ip
address>
config edit firewall set <set
#> rule <rule #> destaddr-
single <ip address>
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask>
O-6
Chart O-1 Firewall Commands
COMMAND DESCRIPTION
This command sets the ZyWALL to log traffic
that matches the rule, doesn't match, both or
neither.
This command sets whether or not the
ZyWALL sends an alert e-mail when a DOS
attack or a violation of a particular rule occurs.
This command sets the rule to have the
ZyWALL check for traffic with this individual
source address.
This command sets a rule to have the
ZyWALL check for traffic from a particular
subnet (defined by IP address and subnet
mask).
This command sets a rule to have the
ZyWALL check for traffic from this range of
addresses.
This command sets the rule to have the
ZyWALL check for traffic with this individual
destination address.
This command sets a rule to have the
ZyWALL check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
Firewall Commands