Chapter 28 Remote Node Setup; Introduction To Remote Node Setup; Remote Node Setup - ZyXEL Communications ZyWall 10W User Manual

ZyWALL Series Internet Security Gateway
Chapter 28

Remote Node Setup

This chapter shows you how to configure a remote node.

28.1 Introduction to Remote Node Setup

A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring a remote node. The following describes how to configure
Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 -
Remote Node Filter.
28.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 Remote Node Setup (shown below).
Then enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for your regular ISP. Enter
2 to open Menu 11.1 Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup
port connection (see the WAN and Dial Backup Setup chapter).
Remote Node Setup 28-1