Configuring Dns; Table 18-6 Snmp - ZyXEL Communications ZyWall 10W User Manual

LABEL
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Trusted Host If you enter a trusted host, your ZyWALL will only respond to SNMP messages from
this address. 0.0.0.0 (default) means your ZyWALL will respond to all SNMP
messages it receives, regardless of source.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the ZyWALL using this
service.
Secure Client IP A secure client is a "trusted" computer that is allowed to communicate with the
Address ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.

18.15 Configuring DNS

Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice versa.
Refer to the Internet Access chapter for more information.
To change your ZyWALL's DNS settings, click REMOTE MANAGEMENT, then the DNS tab. The screen
appears as shown.
Remote Management Screens
ZyWALL Series Internet Security Gateway

Table 18-6 SNMP

DESCRIPTION
18-27