Figure 35-14 Telnet Into Menu 24.7.2: System Maintenance - ZyXEL Communications ZyWall 10W User Manual

35.5.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation, which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading configuration file using TFTP (note
that you must remain on this menu to upload configuration file using TFTP),
please see your manual.
Press ENTER to Exit:

Figure 35-14 Telnet Into Menu 24.7.2: System Maintenance

To upload the firmware and the configuration file, follow these examples
35.5.3 FTP File Upload Command from the DOS Prompt Example
Step 1. Launch the FTP client on your computer.
Step 2. Enter "open", followed by a space and the IP address of your ZyWALL.
Step 3. Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Use "put" to transfer files from the computer to the ZyWALL, for example, "put firmware.bin
ras" transfers the firmware on your computer (firmware.bin) to the ZyWALL and renames it
"ras". Similarly, "put config.rom rom-0" transfers the configuration file on your computer
(config.rom) to the ZyWALL and renames it "rom-0". Likewise "get rom-0 config.rom"
Firmware and Configuration File Maintenance
ZyWALL Series Internet Security Gateway
35-13