Press Space Bar to Toggle.
This table describes the Remote Node PPP Options Menu, and contains instructions on how to configure the
PPP options fields.
FIELD
Encapsulation
Press [SPACE BAR] and then [ENTER] to select CISCO PPP if
your Dial Backup WAN device uses Cisco PPP encapsulation,
otherwise select Standard PPP.
Press [SPACE BAR] and then [ENTER] to select Yes to enable or
Compression
No to disable Stac compression.
24.8 Editing TCP/IP Options
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press [ENTER]
to open Menu 11.3 - Network Layer Options.
Figure 24-6 Menu 11.3: Remote Node Network Layer Options
WAN and Dial Backup Setup
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Enter here to CONFIRM or ESC to CANCEL:
Figure 24-5 Menu 11.2: Remote Node PPP Options
Table 24-6 Remote Node PPP Options Menu Fields
DESCRIPTION
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= None
Metric= 15
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
ZyWALL Series Internet Security Gateway
EXAMPLE
Standard PPP
(default)
No
(default)
24-9