LABEL
Fail Tolerance
Type the number of times your ZyWALL may attempt and fail to connect to the Internet
before traffic is forwarded to the backup gateway.
Period (sec)
Type the number of seconds for the ZyWALL to wait between checks to see if it can
connect to the WAN IP address (Check WAN IP Address field) or default gateway.
Allow more time if your destination IP address handles lots of traffic.
Timeout (sec)
Type the number of seconds for your ZyWALL to wait for a ping response from the IP
Address in the Check WAN IP Address field before it times out. The WAN connection is
considered "down" after the ZyWALL times out the number of times specified in the Fail
Tolerance field. Use a higher value in this field if your network is busy or congested.
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to begin configuring this screen afresh.
8.9
Configuring Dial Backup
To change your ZyWALL's Dial Backup settings, click WAN, then the Dial Backup tab. The screen
appears as shown.
WAN Screens
ZyWALL Series Internet Security Gateway
Table 8-6 Traffic Redirect
DESCRIPTION
8-15