ZyWALL Series Internet Security Gateway
The following table describes the labels in this screen.
LABEL
WAN
The default WAN connection is "1' as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN. The default priority of
Traffic
the routes is WAN, Traffic Redirect and then Dial Backup (dial backup does not apply
Redirect
to all ZyWALL models):
You have two choices for an auxiliary connection in the event that your regular WAN
Dial Backup
connection goes down. If Dial Backup is preferred to Traffic Redirect, then type "14" in
the Dial Backup Priority (metric) field (and leave the Traffic Redirect Priority (metric)
at the default of "15").
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to begin configuring this screen afresh.
8.4
Configuring WAN ISP
To change your ZyWALL's WAN ISP settings, click WAN, then the WAN ISP tab.
encapsulation.
8.4.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.
8-2
Figure 8-1 WAN Setup: Route
Table 8-1 WAN Setup: Route
DESCRIPTION
The screen differs by the
WAN Screens