Ip Alias Setup - ZyXEL Communications ZyWall 10W User Manual

FIELD
IP Subnet Mask
RIP Direction
Version
Multicast
Edit IP Alias
IP Policies
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to save
your configuration, or press [ESC] at any time to cancel.
25.4.1

IP Alias Setup

You must use menu 3.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to configure the second and third network.
Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown next.
LAN Setup
Table 25-2 LAN TCP/IP Setup Menu Fields
Your ZyWALL will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL.
Press [SPACE BAR] and then [ENTER] to select the RIP direction.
Options are: Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are:
RIP-1, RIP-2B or RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a Multicast group. The
ZyWALL supports both IGMP version 1 (IGMP-v1) and version 2
(IGMP-v2). Press [SPACE BAR] and then [ENTER] to enable IP
Multicasting or select None (default) to disable it.
The ZyWALL supports three logical LAN interfaces via its single
physical Ethernet interface with the ZyWALL itself as the gateway
for each LAN network. Press [SPACE BAR] to select Yes and then
press [ENTER] to display menu 3.2.1
You can apply up to four IP Policy sets (from twelve) by typing
their numbers separated by commas.
ZyWALL Series Internet Security Gateway
DESCRIPTION EXAMPLE
255.255.255.0
Both
(default)
RIP-1
(default)
None
Yes
2,7,9,11
25-5