Chapter 19 Ethernet Configuration Commands
Ethernet Configuration Commands can be used to configure the Bandwidth Control,
Negotiation Mode and Storm Control for Ethernet ports.
19.1 interface gigabitEthernet
Description
The interface gigabitEthernet command is used to enter the Interface
gigabitEthernet Configuration Mode and configure the corresponding Gigabit
Ethernet port.
Syntax
interface gigabitEthernet
Parameter
port
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
To enter the Interface gigabitEthernet Configuration Mode and configure port
2:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2
19.2 interface range gigabitEthernet
Description
The interface range gigabitEthernet command is used to enter the interface
range gigabitEthernet Configuration Mode and configure multiple Gigabit
Ethernet ports at the same time.
Syntax
interface range gigabitEthernet
——
The Ethernet port number.
port
port-list
154