Fuji Xerox DocuCentreS2520 User Manual page 50

2 Environment Settings
[Ethernet] is displayed.
 Port Information
TCP Port Number

You can set the Port9100 port No. (a value between 1 and 65535).
You must set a unique number for each port. (Default: 9100)
 Maximum Connections per Port
The maximum number of connections is displayed.
 End of Job Timeout
You can set the amount of time the machine waits before terminating the connection
when incoming data stops (between 2 and 3600 seconds). (Default: 60)
 PDL Switching
[Enabled] is displayed.
2
 [Apply] button
You can apply changes by pressing this button.
Note
SMTP Server (Connectivity > Protocols)
You can set the SMTP server.
 Required Information
 SMTP Server IP Address/Host Name
You can enter the SMTP server's address as an IPv4 or IPv6 address or in FQDN format
(up to 256 characters).
 Port Number for Sending E-mail
You can set the port number used by the SMTP server to send an e-mail (a value between
1 and 65535). (Default: 25)
 Login Credentials for the Machine to access the SMTP Server to send automated e-mails
You can set the authentication method when sending an e-mail by SMTP. You can select
[None] or [SMTP AUTH]. (Default: None)
 Login Name
For SMTP servers requiring authentication, enter the e-mail address of the authenticated
SMTP user (between 1 to 64 ASCII code characters). This can be left blank if SMTP
authentication is skipped.
Password

You can enter the password for authentication (between 1 and 64 ASCII code
characters). This can be left blank if SMTP authentication is skipped.
 Retype Password
You can verify the authentication password you entered by re-entering it here.
 [Apply] button
You can apply changes by pressing this button.
HTTP (Connectivity > Protocols)
You can set the HTTP protocol.
50
• Reboot machine to enable new settings.