Fuji Xerox DocuCentreS2520 User Manual page 220

12 Problem Solving
12
220
Error Code
016-768 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-776 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-781 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-791 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-799 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-981 [Cause]
[Remedy] Press the control panel's <Start> button to redo the operation, or
016-982 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-985 [Cause]
[Remedy] Press the control panel's <Start> button to redo the operation, or
017-745 [Cause]
[Remedy] Press the control panel's <Start> button to redo the operation, or
024-365 [Cause]
[Remedy] Switch off the machine power, make sure that the display is blank,
024-910 [Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change
024-911 [Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change
024-912 [Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change
Cause and Remedy
E-mail data creation failed.
A job is canceled.
Unable to resolve the SMTP server name when sending an e-mail.
The machine could not send data when executing the Scan to PC
(Network) or Scan to E-mail function.
An invalid print parameter is included in the print data of the
application, or the print data and the Print Setup settings may not
match.
The EPC memory is full.
press the <Stop> button to cancel the operation.
The memory is full while scanning the first page with Scan to PC
service.
The attachment size using the Scan to E-mail service exceeds the
maximum size.
press the <Stop> button to cancel the operation.
Exceeded the maximum storage size using SMB of the Scan to PC
service.
press the <Stop> button to cancel the operation.
An error occurred.
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
The paper size set for Tray 1 and the paper size specified for the job
are not the same.
the paper to the specified paper size.
The paper size set for Tray 2 and the paper size specified for the job
are not the same.
the paper to the specified paper size.
The paper size set for Tray 3 and the paper size specified for the job
are not the same.
the paper to the specified paper size.