Network Settings; Ipv4 Address Solution - Fuji Xerox DocuCentreS2520 User Manual

Network Settings

Used to make network environment settings.
For information on how to display the [Network Settings] screen, refer to "System Settings Procedure" (P.136).

IPv4 Address Solution

Sets IPv4.
Get IP Address
Sets the method used to acquire the IP address, subnet mask, and gateway address.
 DHCP/AutoNet
Automatically acquires the IP address, subnet mask, and gateway address from the DHCP
server.
If communication with the DHCP server fails, the AutoIP function is activated to allocate an
IP address (169.254.xxx.xxx). If communication with the DHCP server is later re-established,
the settings are reacquired from the DHCP server.
 Static
Always use the same IP address, subnet mask, and gateway address.
 DHCP
Automatically acquires the IP address, subnet mask, and gateway address from the DHCP
server.
 BOOTP
Automatically acquires the IP address, subnet mask, and gateway address from the BOOTP
server.
 RARP
Automatically acquires the IP address from the RARP server.
IP Address
When [Get IP Address] is set to [Static], the IP address is set by manual input from the
numeric keypad.
Note
 Subnet Mask
When [Get IP Address] is set to [Static], the subnet mask is set by manual input from the
numeric keypad.
Note
 Gateway Address
When [Get IP Address] is set to [Static], the gateway address is set by manual input from the
numeric keypad.
Note
• Enter the IP address in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and 255.
• Enter the subnet mask in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and 255.
• Enter the gateway address in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and
255.

Network Settings

8
147