Operation
Work with Lenses
The lens mount secures the projection lens to the projector and provides setup adjustments to
correct boresight, and manually control focus, zoom and offsets. To electronically control the focus,
zoom and offsets, tap the Lens tab on the touch panel controller.
Reset and calibrated the lens motors when any of the following conditions are met:
• After a lens change.
• After the lens motors are physically moved using the manual adjustment knobs.
• After the projector is moved and/or jostled.
• After the lens motor IMCB has been replaced.
A
Vertical Offset Knob
B
Horizontal Offset Knob
C
Horizontal Boresight Bolt
D
Vertical Boresight Bolt
E
Focus Bolt
F
Lock/Unlock Lever
G
Stabilization Screw
Select a Channel
The projector uses pre-configured channels to determine how to display images from different
sources. Each channel file contains the optimum processing and display settings for the source.
Channels can be selected through the Home tab on Touch Pad Controller (TPC).
38
A
C
B
D
D4K2560/Mirage 4K25 User Manual
G
F
E
020-101076-02 Rev. 1 (11-2013)