Table of Contents
Advertisement
Use
18
7.7.2
Adjusting the quick-release axle
INFORMATION
The assembly tasks described below may only be carried out by qualified personnel�
The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle�
1) Hold the tip of the quick-release axle with a wrench (see Fig� 19, item 1)�
2) Adjust the play by turning the nut on the end of the quick-release axle (see Fig� 19, item 2) in or out�
7.7.3
Adjusting the track width
INFORMATION
The assembly tasks described below may only be carried out by qualified personnel�
The track width of the rear wheels can be subsequently adjusted within a narrow range� This makes it possible to
increase or decrease the distance between the rear wheel and side panel�
1) Remove the rear wheel (see Seite 17)�
2) Loosen the counter nut on the quick-release axle mounting (see Fig� 20, item 1)�
3) Turn the fitting in or out (see Fig� 20, item 2)�
INFORMATION: Adjust the quick-release axle mounting evenly on the left and right side.
4) Firmly tighten the counter nut on the quick-release axle mounting (see Fig� 20, item 1)�
5) Attach the rear wheel (see Seite 17)�
20
18 | Ottobock
19
Invader Pointer
Advertisement
Table of Contents
