Changing The Installation Position Of The Caster Wheels; Assembly G: Rear Wheels; Replacing The Rear Wheels - Otto Bock Voyager Evo Service Manual

Service Work

3.9.6 Changing the Installation Position of the Caster Wheels

INFORMATION
Observe the seat height table in the "Technical Data".
The front seat height can be adjusted by moving the caster wheels in the fork and by selecting the caster wheel
size.
1) Unscrew the screw connection of the threaded axle (see Fig. 60).
2) Remove the threaded axle/spacers.
3) Remove the caster wheel.
4) Insert the threaded axle with the first spacer bushing offset in one of the bore holes.
5) Install the caster wheel.
6) Slide on the second spacer bushing (not illustrated).
7) Tighten the threaded axle to 8 Nm.
→ Once changed, the left and right caster wheels must have the same vertical position in the caster fork.
→ Once the anterior seat height has been adjusted, the rear wheel tracking (see Page 31) and the caster wheel
journal angle (see Page 23) must be checked and adjusted if required.

3.10 Assembly G: Rear Wheels

3.10.1 Replacing the Rear Wheels

1) Press in the button on the quick-release axle.
2) Remove the rear wheel and replace it.
3) Attach the rear wheel to the quick-release axle housing and release the button on the quick-release axle.
4) The quick-release lock engages. The quick-release axle must not be removable after releasing the pushbutton.
24 | Ottobock
57
59
58
60
Voyager evo