Adjusting The Tip Assist; Assembly B: Footrest; Replacing The Tube Footrest - Otto Bock Voyager Evo Service Manual

Service Work

3.4.4.2 Adjusting the Tip Assist

1) Press the spring on the tip-assist (not illustrated).
2) Insert the tip-assist into the accessory mount.
3) Allow the spring to lock in.

3.5 Assembly B: Footrest

3.5.1 Replacing the Tube Footrest

INFORMATION
► When installing the footrest, the lower leg length and footrest angle also need to be adjusted (see Page 12).
► Document the insertion depth before replacing the footrest/footplate.
1) Loosen the Allen head screws (see Fig. 11).
2) Pull out and replace the tube footrest (see Fig. 12).
3) If applicable: Replace clamp sleeves:
→ Pull out the clamp sleeve (see Fig. 13).
→ Position the new clamp sleeve. The flat side has to face in the direction of the clamping screws.
4) Evenly slide the footrest in to the frame up to the recorded insertion depth. Use a soft-faced hammer if neces­
sary.
5) Tighten the Allen head screws to 7 Nm.
10 | Ottobock
9
11
10
12
Voyager evo