Retrofitting A Clamp Block For The Accessory Mount; Replacing The Height Blocks; Replacing A Clamp Block For Height Blocks - Otto Bock Voyager Evo Service Manual

Service Work

3.10.2.2 Retrofitting a Clamp Block for the Accessory Mount

Instead of an axle retainer clamp block, a clamp block for mounting an accessory mount can be installed (see
Page 8).

3.10.3 Replacing the Height Blocks

1) Remove the axle retainer clamp block (see Page 25).
2) Loosen the Allen head screw of the clamp bracket (see Fig. 67).
3) Replace the height block (see Fig. 68).
INFORMATION: The height blocks always have to be replaced in pairs.
4) If applicable: Align the clamp bracket so that the curvature faces the direction of travel.
5) Tighten the Allen head screw of the clamp bracket to max. 7 Nm (see Fig. 67).

3.10.3.1 Replacing a Clamp Block for Height Blocks

1) Remove the rear wheel axle, clamp block of the axle retainer and height block (see previous section).
2) Remove the back attachment clamp block (see Page 16).
3) Loosen the Allen head screws on the seat plate (see Fig. 69, item 1).
4) Loosen the Allen head screw on the clamp block (see Fig. 69, item 2).
5) Replace the clamp block. Tighten the Allen head screws:
→ Allen head screw on the clamp block: 15 Nm
→ Allen head screw on the seat plate: 8 Nm
6) Reinstall the components that were removed.
26 | Ottobock
65
67
66
68
Voyager evo