Format Fax Storage; Event Log (Configuration Menu); Adf Edge Erase; Fb Edge Erase - Lexmark X862de Service Manual

7500-432, -632, and -832

Format Fax Storage

This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1.
Touch Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change the
setting. If no advanced password exists, you can establish one by using the keyboard that appears on the
display.
2.
Touch Submit to save the change.
3.
Touch Back to cancel and return to the Configuration Menu.
Formatting Fax Flash DO NOT POWER OFF appears on the display while the format operation is active.

EVENT LOG (Configuration Menu)

This entry enables you to print a report that contains a limited set of the information that appears in the
Diagnostics version of the Event Log report. See
the full (Diagnostics) printed versions of this report display the same panel messages when they print and follow
the same layout guidelines.
To print the Event Log:
1.
Touch EVENT LOG from the Configuration Menu.
2.
Touch Print Log.
Touch Back to return to the Configuration Menu.
Note: An event log printed from the Configuration Menu will not contain debug information or secondary codes
for 900 service errors. However, the event log printed from the Diagnostics Menu does include this information.

ADF Edge Erase

The ADF Edge Erase and FB Edge Erase settings specify, in millimeters, the size of a border around the
scanned image that will be erased. For copies, the printed page will have a 2 mm no-print border. The larger of
the 2 mm no-print border and the Edge Erase setting will be used in this situation.
To change this setting:
1.
Touch ADF Edge Erase from the Configuration Menu.
touch screen.
2.
Touch to increase the value or
3.
Touch Submit to save the change.
4.
Touch Back to cancel and return to the Configuration Menu.

FB Edge Erase

The ADF Edge Erase and FB Edge Erase settings specify, in millimeters, the size of a border around the
scanned image that will be erased. For copies, the printed page will have a 2 mm no-print border. The larger of
the 2 mm no-print border and the Edge Erase setting will be used in this situation.
To change this setting:
1.
Touch FB Edge Erase from the Configuration Menu.
touch screen.
2.
Touch to increase the value or
3.
Touch Submit to save the change.
3-42
MFP Service Manual
"EVENT LOG" on page
[setting's current value]
to decrease the value.
[setting's current value]
to decrease the value.
3-22. The limited (Configuration) and
appears on the
appears on the
Previous
Next
Go Back