Media Size Mismatch In Width - Lexmark X862de Service Manual

Step
2 Check the switch (exit 2 left door interlock) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Cover and Door.
4. Touch Door E exit2 left.
Does the display change on the operator panel every
time the actuator for the above switch operates?
3 Check the switch (exit 2 left door interlock) for proper
connection.
Is the above switch connected properly?
4 Perform a print test.
Does the error still occur?
5 Perform a print test.
Does the error still occur?

Media size mismatch in width

Step
1 Check the media.
Pull out the tray, and visually check it.
Is the media properly loaded in the tray?
2 Check the media.
Pull out the tray, and visually check it.
Are the front media tray guide assembly, rear media tray
guide, and media tray end guide of tray 1 or tray 2 set
correctly?
3 Check the switch (media size) for proper installation.
Pull out the media tray, and visually check it.
Is the switch (media size) for media tray 1 and media tray 2
installed correctly?
Check
Check
7500-432, -632, and -832
Yes
Reconnect the Go to step 3.
connector of the
printer engine card
assembly.
Replace the switch Replace the
(exit 2 left door connection.
interlock).
Go to "Exit 2 switch
(exit 2 left door
interlock) removal"
on page 4-331.
Replace the exit Problem solved.
interface card
assembly.
Go to "Exit
interface card
assembly removal"
on page 4-117.
Go to step 5.
Replace the printer Problem solved.
engine card
assembly.
Go to "Printer
engine card
assembly removal"
on page 4-119.
Yes
Go to step 2. Load media
properly.
Go to step 3. Set the guides
properly.
Go to step 4. Install the switch
(media size) for
each media tray
correctly.
Diagnostic information
Previous
No
Next
Go Back
No
2-177