Sensor (Adf Registration) On Jam Adf Simplex Side 1 - Lexmark X862de Service Manual

Step
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
5 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

290.11 Sensor (ADF registration) on jam ADF simplex side 1

Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes, or excessive
wear?
2 Check the ADF rolls for wear.
Is the ADF feed/pick roll assembly or the ADF separation roll
guide assembly free of excess wear?
3 Check the media path for contaminates.
Is the media path free of excess media dust and foreign
objects such as paper clips and staples?
Check
Check
7500-432, -632, and -832
Yes No
Replace the Go to step 5.
ADF controller
card assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-175.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-130.
Yes No
Go to step 2. Remove damaged
original document,
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to step
2.
Go to step 3. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
guide assembly.
Go to "ADF feed/
pick roll
assembly
removal" on
page 4-186
"ADF separation
roll guide
assembly" on
page 4-203.
Go to step 4. Remove all
contaminates from
the media path.
Diagnostic information
Previous
Next
Go Back
or
2-91