Sensor (Adf Registration) Off Jam - Lexmark X862de Service Manual

290.13 Sensor (ADF registration) off jam

Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes, or excessive
wear?
2 Remove the registration pad cover, and clean the black
registration pad shown in the diagram below.
1. Raise the ADF to the full upright position.
2. Remove the two screws securing the registration pad
cover.
3. Remove the registration pad cover.
4. Clean or replace the black registration pad of excess
paper dust.
5. Reinstall the registration pad cover.
Place several undamaged documents in the ADF, and
perform an ADF test.
Does the problem remain?
3 Check the ADF rolls for wear.
Is the ADF feed/pick roll assembly or the ADF separation roll
guide assembly free of excess wear?
Check
7500-432, -632, and -832
Yes No
Go to step 2. Remove damaged
original document,
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to step
2.
Go to step 3. Problem solved.
Go to step 4. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
guide assembly.
Go to "ADF feed/
pick roll
assembly
removal" on
page 4-186
"ADF separation
roll guide
assembly" on
page 4-203.
Diagnostic information
Previous
Next
Go Back
or
2-95