Testing The Manual Scanner Registration - Lexmark X862de Service Manual

Testing the manual scanner registration

Note: Machine must be in Standard User Mode.
To properly position the registration test original page on the flatbed scanner and the ADF side 1 and ADF side 2,
follow the graphic below:
Warning: Ensure that the registration test original page is properly positioned according to the diagrams or
registration and margins cannot be properly adjusted.
1.
Place the registration test original page on the flatbed scanner according to the graphic below.
2.
Make a copy of the registration test original page, and mark it "Flatbed."
3.
Place the registration test original page, image side up, in the ADF according to the diagram below. This will be
the ADF side 1 registration test.
4.
Make a copy of the registration test original page, and mark it "ADF side 1."
5.
Place the registration test original page, image side down, in the ADF according to the diagram below. This will
be the ADF side 2 registration test.
6.
Select "2 sided to 2 sided" while in copy mode to ensure that the rear side of the test original is copied.
7.
Make a copy of the registration test original page, and mark it "ADF side 2."
Note: You should now have three test copies of the registration test original page.
Leading
edges
ADF side 1
Flatbed
ADF side 2
7500-432, -632, and -832
3-27
Diagnostic aids
Previous
Next
Go Back