Engine Setting 1 To; Model Name; Configuration Id - Lexmark X862de Service Manual

7500-432, -632, and -832
Printed Page Count
The value of this setting enables you to gauge the amount of usage on a device.
The Printed Page Count cannot be reset by the servicer.
Permanent Page Count
The value of this setting indicates the total number of pages that have been printed by the printer.
The Permanent Page Count cannot be reset.
Serial Number
This printer setting records the printer's serial number that was assigned by the manufacturer. When you select
this setting, a replica of a keyboard appears on the display that enables you to edit the serial number.

Engine Setting 1 to 16

These settings are used by Engine code ECs to fix field problems.
Warning: Do not change these settings unless requested to do so by your next level of support.

Model Name

The model name can only be viewed and cannot be changed.

Configuration ID

The two configuration IDs are used to communicate information about certain areas of the printer that cannot be
determined using hardware sensors. The configuration IDs are originally set at the manufacturer, however you
may need to reset Configuration ID 1 or Configuration ID 2 when you replace the printer engine card assembly.
This printer uses two Configuration IDs, each of which consists of eight digits. The first seven digits in each ID
are hexadecimal numbers while the last digit is a checksum of the preceding seven hexadecimal digits. Each ID
can contain a combination of the digits 0 through 9 and the characters A to F.
If the printer's firmware detects that either of the printer's Configuration IDs has not been defined or is invalid,
then the following occurs:
1.
The firmware automatically uses the Configuration IDs defined for the printer's standard model.
2.
The Configuration ID setting is the only item that appears when you open the Diagnostics menu.
When the printer is not in Diagnostics mode, Check Config ID appears on the display.
3.
Note: Each of the above conditions will remain until a valid value is entered for Configuration ID 1 and
Configuration ID 2.
3-20
MFP Service Manual
Previous
Next
Go Back