Removing Electronic Oven Control Board - Thermador CM301B Service Manual

Lit. No. 94-30-006B
REMOVING THE ELECTRONIC OVEN CONTROL BOARD
WARNING
Turn off the electrical power going to the
oven before servicing.
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
1. Turn off the electrical power going to the
oven.
2. Pull the oven out of its mounting location
so that you can access the trim and ple-
num covers.
3. Remove the trim and top plenum covers
from the oven (see Page 10).
4. Remove the four screws from the control
panel mounting bracket, pull the catches
out of the ball studs at each end of the
bracket, (see the small inset), and remove
the bracket from the oven.
Ball Stud
2 Screws
Control Panel
Mounting Bracket
5. Disconnect the wires from the electronic
oven control board connectors.
6. Remove the six screws from the electronic
oven control board.
7. Lift the front of the electronic oven con-
trol board and slide the three wire ties off
the front spacers, then remove the board
from the oven.
Tie
Catch
2 Screws
If necessary, refer to Page 113 for the wire
connection callouts for single and double
electronic oven control boards.
Page 11
CM Oven Service Manual
3 Screws
3 Screws
Tie
Tech Tip!!
Tie