Lit. No. 94-30-006B
9.
To remove the high-temp cutout:
a) Use an angled 1/4˝ socket and remove
the two hex-head screws from the
high-temp cutout bracket. Pull the cut-
out forward as far as the wires will al-
low.
b) Disconnect the wires from the termi-
nals.
High-Temp
Cutout
Hex-Head Screws
10. To remove the monitor and secondary
switch assembly:
a) Use an angled screwdriver and remove
the four screws and lockwashers from
the switch assembly. Pull the assembly
forward as far as the wires will allow.
b) Disconnect the wires from the switch
terminals.
BK-128 & WH-129 WH-132 & WH-133
BK-33
BK-34
Secondary Switch
Page 27
CM Oven Service Manual
Screw &
Lockwasher
(1 of 4)
Monitor Switch