Removing Oven Door Gasket - Thermador CM301B Service Manual

CM Oven Service Manual
REMOVING THE OVEN DOOR GASKET
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts.
There are sharp edges present and you
can cut yourself if you are not careful.
CAUTION: Before you replace the fiberglass
gasket on the oven door, make sure that the
oven control is turned OFF, and that the oven
is cool.
Refer to illustration, below, for the following
steps.
1. Open the oven door to its fully open po-
sition.
2. Pull the ends of the old gasket out of the
holes in the door (see Inset 1 on the illus-
tration).
3. Working from one end of the gasket to
the other, carefully pull the clips that are
4.
5.
6.
7.
8.
INSET 1
OLD
Push End Of
Gasket Into Hole
Pull End Of Gasket
With Eraser End Of Pencil
Out Of Hole
OVEN DOOR
Gasket
OLD
GASKET
Pull Clips
Out Of Holes
Push Clips
In Oven Door
Into Holes
INSET 2
Page 100
attached to the gasket out of the holes in
the oven door (see Inset 2 on the illustra-
tion).
Position the new fiberglass gasket around
the oven door so that the clips are near
the holes.
Working from one end of the gasket to the
other, insert the gasket clips into the holes
in the oven door. NOTE: Once inserted,
gently pull on the clip to make sure that it
is locked into place.
Using the eraser end of a pencil, push the
ends of the gasket fully into the holes in
the oven door.
Check the entire gasket to make sure that
all of the clips are properly inserted, and
that it is flush and even with the surface
of the door.
Close the oven door and check to make
sure that the gasket fits firmly and evenly
with the front of the oven.
Pencil
NEW
Clip
NEW
GASKET
Lit. No. 94-30-006B