Removing An Oven Door Hinge, Actuator Arm, Center Glass, Rf Screen, & Inner Glass - Thermador CM301B Service Manual

CM Oven Service Manual
REMOVING AN OVEN DOOR HINGE, ACTUATOR ARM,
CENTER GLASS, RF SCREEN, & INNER GLASS
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
1. Remove the upper (or single) oven door
from the unit (see Page 42) and lay it on a
padded surface with the glass side down
and the bottom edge facing you.
2. Remove the two bottom edge screws and
the two top screws from the liner. This will
separate the glass and liner sections of the
door (see Page 47).
3. Lift the door liner assembly off the door
glass assembly and lay it liner-side-down
on the padded work surface. NOTE: Set
the oven door glass assembly out of the
way so it does not get damaged.
4. To remove an oven door hinge:
a) Remove the mounting screw at the bot-
tom edge of the door.
b) Slide a piece of pipe over the end of
the hinge and push it against the spring
until you can unlock the U-clip, then
allow the hinge to return to its un-
locked position, and remove the pipe.
c) Unhook the hinge at the top, and re-
move the hinge.
Hinge
Screw
Unhook Hinge
Page 46
5.
To remove the actuator arm:
a) Remove the four screws from the baffle
and remove the baffle.
b) Remove the four screws from the ac-
tuator arm bracket and remove the ac-
tuator arm from the liner.
Actuator Arm
Bracket
Screw (1 of 4)
Top Screws
Bottom Screws
6. To remove the center glass:
a) Remove the four screws from the insu-
lation cover and remove the cover.
Top Screws
Center Glass
Insulation
Cover
Bottom Screws
Lit. No. 94-30-006B
Baffle