Thermador CM301B Service Manual page 31

Lit. No. 94-30-006B
9. Cut the leads of the new light assembly
approximately 3˝ from the body.
10. Remove 3/8˝ of insulation from the cut
lead ends and the wiring harness.
11. Twist two small wire nuts over the ends
of the leads.
When you reassemble the halogen light as-
sembly:
1. Position the wiring neatly inside the
oven liner cutout for the halogen light
and press the assembly into place so its
edges are flush with the outside of the
liner.
Keep Edges
Flush With Liner
2. Install the bulb in the socket.
3. When you reinstall the metal screen, do
not install screws at the four corners (see
Step 6 on the previous page).
4. When you reinstall the rack support,
make sure you position it with the stop
towards the back (see Step 4 on the pre-
vious page).
Page 29
CM Oven Service Manual
Tech Tips!!
Install Halogen Bulb