Lit. No. 94-30-006B
d) Remove the two pieces of insulation
from the top of the waveguide.
Insulation
e) Remove the four mounting screws
from the magnetron and lift it off the
waveguide.
Screw
Screw
7.
To reinstall the magnetron on the
waveguide, use the cross-tightening
method to tighten the four screws, as fol-
lows:
a) Loosely install screw #1.
b) Loosely install screw #2 in an alternate
(across the transformer) mounting
hole.
Insulation
8.
Screw
Screw
Page 23
CM Oven Service Manual
c) Repeat steps a and b for screws #3 and
#4 so that all four screws are loosely
installed.
d) Alternately tighten screws #1 through
#4 until they are snug. The base of the
magnetron should be perfectly paral-
lel with the waveguide to operate prop-
erly.
2
3
To remove the magnetron thermal cut-
out:
a) Disconnect the wires (BK-130 & BK131)
from the terminals.
b) Remove the two screws.
Screw
Screw
4
1