Thermador CM301B Service Manual page 41

Lit. No. 94-30-006B
7. Remove the four bracket screws from the
lower crossflow blower assembly and re-
move the assembly from the oven.
8. Disconnect the two motor wires (BU-74
& WH-75) and remove them from the wire
wrap.
Motor Connectors
Crossflow Blower
Assembly
9. Remove the nine screws from the blower
mounting plate.
Plastic Grommet
Blower Mounting Plate
10. Remove the plastic grommet from the
blower mounting plate hole and remove
the grommet from the wiring.
11. Bend the blower mounting plate down 90˚
along the perforated edge.
Bend Plate Down 90˚
Screws
(2 of 4)
Screw (1 of 9)
Page 39
12. Bend the flange covering the hidden bake
element down as necessary to remove the
element.
Bend Flange Down To Access Bake Element
13. Disconnect the two orange wires (22 & 29)
from the bake element terminals.
14. Remove the four screws from the mount-
ing and element brackets (2 each).
Mounting Bracket Element Bracket
Mtg. Bracket Element Bracket
Screw (1 of 2)
15. Position the wiring to the side and pull
the bake element and mounting bracket
out of the oven.
Pull Bake Element &
Bracket Out
CM Oven Service Manual
Screws
Wiring