Removing Fuseblock & Microwave Pcb Control - Thermador CM301B Service Manual

CM Oven Service Manual
WARNING
Turn off the electrical power going to the
oven before servicing.
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
1. Turn off the electrical power going to the
oven.
2. Pull the oven out of its mounting location
so that you can access the trim and ple-
num covers.
3. Remove the trim and top plenum covers
from the oven (see Page 10).
4. Remove the control panel mounting
bracket (see Step 4 on Page 11).
5. To remove the fuseblock:
a) Pull the fuse out of the clips.
b) Remove the mounting screw from the
center of the fuseblock.
Microwave
PCB Control
REMOVING THE FUSEBLOCK
& MICROWAVE PCB CONTROL
Fuse &
Fuseblock
20 Amp
Fuse
BK-125
6. To remove the microwave PCB control:
a) Disconnect the wires from the termi-
nals.
b) Remove the four mounting screws
from the bracket.
Page 12
Lit. No. 94-30-006B
BK-126
Screw
Screws
3 White
4 Screws
BK 127
BK 130
2 Yellow
2 Orange
Screws