Removing The Oven Temperature Sensor - Thermador CM301B Service Manual

Lit. No. 94-30-006B

REMOVING THE OVEN TEMPERATURE SENSOR

WARNING
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
CAUTION
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
Refer to illustration, below, for the following
steps.
1. Turn off the electrical power to the oven.
2. To make servicing easier, remove the oven
door (see Page 99).
3. Remove the racks from the oven.
Oven Liner
Inline Splices
Slide Fiber Sleeving Over
Wires & Against Collar Of
Oven Temperature Sensor
4. Remove the screws from the bracket and
pull the oven temperature sensor forward
until the wire connectors are through the
opening.
5. Cut the inline splices from the oven tem-
perature sensor and main harness wires.
6. Connect the wires from the new oven tem-
perature sensor to the main harness wires
with two red inline splices. After you con-
nect the wires, pull on them to make sure
that the inline splices are secure.
7. Use a screwdriver or stiff wire and push
the wires into the back of the oven as far
as they will go, then install the oven tem-
perature sensor in the oven liner with its
two screws.
8. Reassemble the oven.
TECH
TIP!!
Be sure the oven temperature sensor connec-
tors are pushed back into the rear of the oven
and out of the oven heat zone.
Collar
OVEN TEMPERATURE
SENSOR
Page 87
CM Oven Service Manual
MOUNTING
SCREW