Table of Contents
Advertisement
Service Manual for Thermador Masterpiece J-Series Built-in Wall Ovens
6. Select 1 - if you wish to lower the oven temperature by the
offset amount or 2 + if you wish to raise the oven temperature
by the offset amount.
7. Using the numeric keypad, enter the desired offset amount.
8. Press
.
BACK
9. Select 1 for Back without changes or 2 Back with changes.
10. Press
to exit user settings.
INFO
•
To view the offset, repeat steps 1 – 6.
•
To revert back to default settings, press
Standard.
•
To change the offset, first revert back to default settings, then
repeat steps 1 – 10.
A +25° offset will result in a cavity temperature of 350° when the
temperature knob is set to 325° for any of the cooking modes listed
above. Similarly, a -25° offset will result in a cavity temperature of
300° when the temperature knob is set to 325°.
The adjusted temperature cannot be less than 250°F or greater than
550°F.
6.8
Broil Element
All single oven models, as well as the upper cavity of double oven
models, have a 10-pass (240V 3600W) broil element.
Refer to the Element Strip Diagram to test the element at the control
module, or:
1. Remove the 2 T20 screws securing the element to the broil
reflector.
2. Remove the 2 T20 screws on either side of the element
terminals.
Copyright by BSH Home Appliances Corporation (Revised May 2013)
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
6.9
, then select 2 for
INFO
6.10
1901 Main Street, Suite 600, Irvine CA
58300000170514 ARA EN B
3. Pull the element toward you so that the terminal wires are
inside the oven cavity.
4. Disconnect the wires from the inner broil element terminals.
5. Use an ohmmeter to check for resistance of ~16 ohms.
User Interface
Figure 13 reflects the 3 variations of the T1 user interface used in the
Masterpiece Series ovens.
Figure 13 T1 User Interface variations
The user interface control board is assembled onto a chassis and the
entire assembly is serviced as a single unit.
After replacing the user interface board, always confirm that the option
code is set correctly, reset the oven, and test operation. See section
7.2 Service Mode/Setting Option Code for additional information.
PC Control Module (Relay Board)
To access the PC control module, pull the unit out from the wall 15-16
inches, and remove the access panel (3 T20 screws) on the top of the
unit. See Figure 14.
Page 17 of 37
ME models (T1S1)
MED Single/combo
models (T1S2)
MED Double models
(T1D)
800 444-9091
Hide quick links:
Advertisement
Table of Contents
