Engine Wiring - Factory Five Racing Mk4 Roadster Assembly Manual

Complete kit
Hide thumbs Also See for Mk4 Roadster:
Table of Contents

Advertisement

Tighten the accelerator cable locknut.
Push the ball stud retainer onto the throttle pedal.
While pulling the cable tight, push the accelerator pedal up until it hits the frame and align the ball stud
retainer with the cable.
Mark on the cable where the retainer ends.
Measure ⅜" from the mark on the cable towards the end of the cable and re-mark the cable.
Using a pair of wire cutters, cut the cable at the new location marked.
Remove the ball stud retainer from the accelerator pedal.
Push and twist the ball stud retainer onto the end of the cable and attach the ball stud retainer using a
hex key.
After driving the car for the first time you may want to adjust the pedal location for optimum heal/toe
and shoe size differences.

Engine Wiring

Drill,
/
" drill bit, silicone, caulk gun, rivet gun
1
8
Mounted aluminum, secondary body fasteners
Refer to either the chassis harness instructions or if you are running a stand alone harness refer to
those instructions.
233
www.factoryfive.com
508-291-3443
/
"
5
64

Advertisement

Table of Contents
loading

Table of Contents