Factory Five Racing Mk4 Roadster Assembly Manual page 190

When you are happy with the routing use the small insulated line clips and / " rivets to hold it in place.
3
16
Use another of the long 60" brake lines and route from the drivers side adapter back to the master
cylinder. Either master cylinder can be used for front or rear just mark which one is which for when you
set the brake bias. A clean routing of the line is to follow either ¾ in. tube back to the footbox. This
routing follows the upper tube and goes through a / " hole drilled in the footbox front plate.
7
16
189
www.factoryfive.com 508-291-3443