Roll Bar - Factory Five Racing Mk4 Roadster Assembly Manual

Complete kit

Hide thumbs Also See for Mk4 Roadster:

Table of Contents

Roll bar

Drill, 1¾" hole saw, air saw or jig saw, file

1.50" driver side Rollbar.

The roll bar holes are marked on the body and need to be cut out using a 1¾" holes saw. The front two

holes are cut centering the saw in the marked circle and drilling vertically to match the angle the bar

comes through the body.

www.factoryfive.com

508-291-3443

Do you have a question about the Mk4 Roadster and is the answer not in the manual?