Factory Five Racing Mk4 Roadster Assembly Manual page 185

The crossed off parts in the picture above are for the stock Mustang Master cylinder and flexible
brake lines so are not used. The U-nuts, washers and button head screws are for the e-brake
handle mounting. The small black screws are for the e-brake boot
Unpack the remaining hardware from the front brake assembly.
Lay out the various lengths of brake line so you can see what you have to work with. Like the fuel lines,
there are many ways to run these lines but you must be very careful to keep them protected from moving
parts, heat, or being to close to the bottom of the car.
184
www.factoryfive.com 508-291-3443