Optional Parts - Factory Five Racing Mk4 Roadster Assembly Manual

Caster: 7°
Camber: -0.5°
1
Total Toe: / "
16
Adjusting the upper control Arm
Use the diagram below for reference.
Slightly loosen the three pivot bolts using a ⅝" and
Loosen the jam nuts on both ends of each adjusting tubes using a 1⅛" wrench. Turn the adjusting tubes
to lengthen or shorten the arm.
After you have adjusted the arm to the desired length, tighten down the jam nuts against the adjusting
tubes, and then tighten each of the three pivot bolts. Torque the pivot bolts to 42 lbft.
Grease both ends using chassis grease frequently to insure smooth, trouble free operation.
There should never be more than 1" of thread showing past the tightened down jam nuts on
either end of both adjusting tubes.
The Pivot Bolts must be loosened while the car is aligned and retightened afterwards

Optional Parts

Instructions are included separately with each option when shipped.
/ " wrench.
11
16
480
www.factoryfive.com 508-291-3443