Drive Belt Specifications - Arctic Cat Cougar Service Manual

DRIVE SYSTEM
16. To assemble the driven pulley, reverse the
disassembly procedure while noting the follow-
mg:
a. Apply Loctite 242 (blue) to all screw
threads.
b. To properly install the torque bracket ( 6,
Figure 78), first install the key (3, Figure
78). Place the torque bracket on the spring
with the outer end of the spring inserted into
the middle hole in the cam. While holding
Table 1 DRIVE BELT
Model Part No.
1990
Prowler, El Tigre EXT 0227-032
1991-1992
Prowler, Cougar,
EITigreEXT 0227-032
1993
Prowler, Cougar 0227-032
440ZR
0627-009
EXT 550, EXT 580 0627-012
580ZR 0627-009
1994
Cougar, Prowler
0227~103
ZR 440, EXT 580, ZR 580 0627-012
1995
Cougar, Prowler 2-Up 0627-012
Z440 0627-012
ZR 440, EXT 580,
EXT 580 EFI, ZR 580,
ZR 580 EFI 0627-012
355
the torque bracket, tum the movable sheave
counterclockwise approximately 120° to
tension the spring. Push down the torque
bracket so it bottoms on the buttons. Install
the washer and snap ring.
NOTE
Install the snap ring so the sharp side is
out, away from the washer.
c. Be sure alignment marks are aligned.
SPECIFICATIONS
Width mm (in.) Circumference em (in.)
34.1-35.7 110.5-111.1
(1.344-1.406)
(43.50-43.74)
34.1-35.7 110.5-111.1
(1.344-1.406)
(43.50-43.74)
34.1-35.7 110.5-111.1
(1.344-1.406) (43.50-43.74)
34-36
120-121
(1.339-1.417)
(47.24-47.64)
34-36 120-121
(1.339-1.417) (47.24-47.64)
34-36 120-121
(1.339-1.417)
(47.24-47.64)
34-36 110.3-111.1
(1.339-1.417) (43.43-43.74)
34-36 120-121
(1.339-1.417) (47.24-47.64)
34-36 120.8-121.3
(1.339-1.417) (47.56-47.76)
34-36 120.8-121.7
(1.339-1.417)
(47.56-47.91)
34-36 120-121
(1.339-1.417) (47.24-47.64)
(continued)