Cooling Fan Assembly; Fan Cooling System Diagram - Arctic Cat Cougar Service Manual

COOLING SYSTEMS
12. Refer to Checking/Adjusting Fan Belt Ten-
sion in Chapter Three if the measured belt de-
flection is incorrect.
13. When the belt tension is correct, install the
recoil starter and fan intake cover.
Cooling Fan Assembly
The procedure for removing and servicing the
cooling fan, upper shaft and fan housing will
301
depend upon the amount of other service re-
quired. Refer to Figure 1.
1. Remove the fan drive belt as described in this
chapter.
2. Detach the wires from the CDI unit and igni- ,
tion coil.
3. Remove the cylinder cowling or unbolt the
fan housing from the cylinder cowling.
4. Remove the inner pulley half and Woodruff
key from the shaft.
FAN COOLING SYSTEM
I
1. Bolt
2. Lockwasher
3. Washer
4. Cover
5. Cooling case
6. Stud
7. Nut
8. Nut
6
9. Washer
~/7 10. Pulley half
"
11. Shims
12. Pulley half
~
13. Bearing
14. Circlip
15. Spacer
16. Bearing
17. Key
18. Fan
19. Lockwasher
20
20. Belt
21. Drive pulley
22. Fan assembly
23. Shaft
24. Washer
25. Lockwasher
26. Bolt
/
22