Engine Identification Table - Arctic Cat Cougar Service Manual

202
NOTE
Make sure the drive shaft tang (Figure
141) and the slot in the pump shaft are
aligned when installing the pump.
6. Install the oil injection pump using a new
sealing ring or gasket between the pump and the
retainer. Tighten the two retaining screws to the
torque listed in Table 10.
7. Attach the oil line to the crankcase and to each
cylinder's injection fittings.
8. On liquid-cooled models, observe the follow-
ing:
a. Lightly coat the seal surface (A, Figure
138) on the impeller with grease.
b. Install the impeller. Push the impeller onto
the shaft until seated.
CHAPTER FIVE
c. Make sure the impeller retaining screw is
fitted with the special washer with the rub-
ber side toward the impeller.
d. Coat the threads of the impeller retaining
screw (Figure 128) with Loctite 242 and
tighten the screw to the torque listed in
Table 10.
e. Position the 0-ring in the coolant pump
cover as shown in Figure 142.
NOTE
Apply the sealer specified in substep 8f
only to the mating suifaces of the case
halves.
f. Apply high temperature silicone sealer to
the mating surfaces of the crankcase halves
and install the coolant pump cover. Tighten
the retaining screws securely.
Table 1 ENGINE IDENTIFICATION
Engine
Bore/stroke Displacement
Model cooling type mm (in.) cc (cid.)
1990
Prowler Liquid 68x60
435.8
EITigreEXT
Liquid
72x65 529
El Tigre Mountain Cat Liquid
72x65 529
1991
Prowler Air/fan 68x60 435.8
Prowler Mountain Cat Liquid 68x60 435.8
Cougar Liquid 73.4 x65 550
EITigreEXT Liquid 72x65 529
El Tigre Mountain Cat Liquid 72x65 529
(continued)