Warning Lamps; High Beam Indicator Lamp - Arctic Cat Cougar Service Manual

286
Bulb Replacement
1. Open the hood.
2. Locate the bulb socket at the affected meter
assembly and pull the bulb socket out of the
meter assembly.
3. Replace the bulb.
Jl:nstrument RemovaVInstallation
1. Open the hood.
2. Disconnect the electrical connectors at the
instrument.
3. Pull the bulb socket out of the instrument
assembly.
4. Disconnect the speedometer cable (A, Figure
40) at the instrument.
5. Remove the nuts (B, Figure 40) securing the
mounting bracket and remove the instrument.
6. Installation is the reverse of the preceding
steps.
WARNING LAMPS
Several different indicator lights may be lo-
cated on the dash or console. Service is similar
for most of the lamps and usually limited to
installing a new bulb. Some of the warning lamps
may be connected to a wire from a sensor (send-
ing unit).
High Beam Indicator Lamp
The high beam indicator lamp lights whenever
the headlight is on HIGH beam. Replace the bulb
if it does not light.
1. Open the hood.
2. Disconnect the electrical connector at the
high beam indicator lamp and remove the lamp.
3. Reverse to install. Check operation by turning
the headlight to HIGH. The lamp should come
on.
CHAPTER NINE
Oil Level Warning Lamp
The oil tank is equipped with an oil level
sensor that is wired to the injection oil level
warning lamp on the instrument panel. When the
oil level in the tank reaches a specified low point,
the warning lamp will light.
The oil injection level warning lamp lights
whenever the brake lever is operated. If the lamp
does not light during brake operation, replace the
lamp as follows:
1. Open the hood.
2. Disconnect the electrical connector at the oil
level pilot lamp and remove the pilot lamp.
t·
~}::~
..• 1/"o.
r.
,:~··.··.·.~.
····- ;._;,.;·
~·.
:.::>'.
t .••.•.• ~. ....... :,
---·-
EXTRA TRAVEL. TUNNEL.
'
.
'